lemon-mirror:
Home >> Mercury >> 2008 >> Sable Base, FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Servicing >> Lower Intake Manifold >> Installation

Lower Intake Manifold: Installation

  1. Using new intake manifold and thermostat housing gaskets, install the lower intake manifold and the 10 bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    2. Fig 1: Installing Lower Intake Manifold Bolts In Sequence
    GF0029084Courtesy of FORD MOTOR CO.
  2. Install the 3 thermostat housing-to-lower intake manifold bolts.
    • Tighten to 10 Nm (89 lb-in).
  3. Install the fuel rail. For additional information, refer to FUEL CHARGING AND CONTROLS - 3.5L article.
  4. Fill and bleed the cooling system. For additional information, refer to ENGINE COOLING article.
· About lemon-mirror