Steering Column Light Switch Test
Remove upper and lower steering column covers. Disconnect light switch harness connectors "A" (9-pin) and "B" (6-pin). Check continuity between appropriate harness connector terminals. See STEERING LIGHT SWITCH CONTINUITY TEST table. Replace steering column light switch if necessary.
STEERING LIGHT SWITCH CONTINUITY TEST
| Terminal No. | Test Condition | ||
|---|---|---|---|
| Connector "A" (9-Pin) | |||
| Parking Light ON | |||
| 5 & 8 | Continuity | ||
| Headlight ON | |||
| 2, 5 & 8 | Continuity | ||
| Connector "B" (6-Pin) | |||
| Low Beam | |||
| 3 & 4 | Continuity | ||
| High Beam | |||
| 4 & 6 | Continuity | ||
| Passing-Low Beam | |||
| 3 & 4 | Continuity | ||
| 1, 2 & 6 | Continuity | ||
| Passing-High Beam | |||
| 1, 2 & 6 | Continuity | ||