lemon-mirror:
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2001 Montero >> Pattern 6 >> Test Procedure

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Let the engine idle for 30 seconds. (During the monitor)
  3. Accelerate the vehicle for 2 seconds at the following conditions. (During the monitor)
    • Engine speed: More than 2,000 r/min
    • Engine load: More than 60%
    • Throttle position sensor output voltage: More than 3.5 volts
  4. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 4 again. Confirm that the diagnostic trouble code (DTC) is not output.

· About lemon-mirror