Fastener Tightening Specifications
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION | |
|---|---|---|
| Transaxle | Roll stopper bracket | 70 +/- 10 N.m (52 +/- 7 ft-lb) |
| Control cable bracket | 23 +/- 3 N.m (17 +/- 2 ft-lb) | |
| Eye bolt | 24 +/- 3 N.m (18 +/- 2 ft-lb) | |
| Oil cooler feed tube | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Input shaft speed sensor | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Output shaft speed sensor | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Manual control lever | 22 +/- 3 N.m (16 +/- 2 ft-lb) | |
| Park/neutral position switch (PNP switch) | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Sealing cap | 5.0 +/- 1.0 N.m (43 +/- 9 in-lb) | |
| Valve body cover | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Manual control shaft detente | 6.0 +/- 1.0 N.m (52 +/- 9 in-lb) | |
| Valve body mounting bolt | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Fluid temperature sensor | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Torque converter housing | 48 +/- 6 N.m (36 +/- 4 ft-lb) | |
| Oil pump | 29 +/- 2 N.m (21 +/- 2 ft-lb) | |
| Rear cover | 23 +/- 3 N.m (17 +/- 2 ft-lb) | |
| Transfer drive gear | 34 +/- 2 N.m (25 +/- 1 ft-lb) | |
| Output shaft jam nut | 170 +/- 10 N.m (125 +/- 7 ft-lb) | |
| Output shaft bearing retainer | 29 +/- 2 N.m (21 +/- 2 ft-lb) | |
| Components | Differential drive gear | 135 +/- 5 N.m (100 +/- 4 ft-lb) |
| Solenoid valve support | 6.0 +/- 1.0 N.m (52 +/- 9 in-lb) | |
| Valve body | 11 +/- 1 N.m (95 +/- 9 in-lb) | |
| Plate | 6.0 +/- 1.0 N.m (52 +/- 9 in-lb) | |