lemon-mirror:
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Electrical >> Battery Cables >> Installation >> Negative

Battery Cables: Installation: Negative

Fig 1: Identifying Bolt, Battery Negative Cable Terminal Clamp And Negative Cable Eyelet
G04857382Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Position the battery negative cable (4) in the vehicle and into the engine harness conduit.
  2. One at a time, install the battery cable retaining pushpins (5), fasteners and routing clips until the cable is secure in the vehicle.
  3. Install the bolt (2) securing the negative cable eyelet (3) to the left front fender. Tighten the bolt to 20 N.m (15 ft. lbs.).
    Fig 2: Identifying Negative Cable, Engine And Bolt
    G04854914Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Raise the vehicle on a hoist, (Refer to GENERAL/HOISTING/STANDARD PROCEDURE ).
  5. Install the bolt (3) securing the negative cable (1) to the engine block (2). Tighten the bolt to 16.5 N.m (145 in. lbs.).
    Fig 3: Identifying Bolt, Battery Negative Cable Terminal Clamp And Negative Cable Eyelet
    G04854921Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Lower the vehicle.
  7. Connect the battery negative cable terminal clamp (4). Tighten the battery terminal clamp pinch-bolt hex nut to 5 N.m (45 in. lbs.).
  8. Check the vehicle for normal operation.
· About lemon-mirror