lemon-mirror:
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Electrical >> Battery >> Removal

Engine Electrical: Battery: Removal

Fig 1: Removing Battery Terminal Using Battery Terminal Puller
G04854903Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE: It may be necessary to use a battery terminal puller (2) if the battery cable terminal clamps are seized on to the battery posts.
Fig 2: Identifying Battery System Components
G04854895Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
  2. Loosen the battery negative cable terminal (4) clamp pinch-bolt hex nut.
  3. Disconnect the battery negative cable terminal clamp from the battery negative terminal post. If necessary, use a battery terminal puller to remove the terminal clamp from the battery post.
  4. Loosen the battery positive cable terminal (2) clamp pinch-bolt hex nut.
  5. Disconnect the battery positive cable terminal clamp from the battery positive terminal post. If necessary, use a battery terminal puller to remove the terminal clamp from the battery post.
    Fig 3: Identifying Battery Thermal Guard, Battery, Hold Down And Bolt
    G04854905Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Remove the battery thermal guard (1).
  7. Remove the battery hold down (4) and bolt (3) from the battery (2).
    WARNING: WEAR A SUITABLE PAIR OF RUBBER GLOVES WHEN REMOVING A BATTERY BY HAND. SAFETY GLASSES SHOULD ALSO BE WORN. IF THE BATTERY IS CRACKED OR LEAKING, THE ELECTROLYTE CAN BURN THE SKIN AND EYES.
  8. Remove the battery (2) from the vehicle.
· About lemon-mirror