Removal And Installation: Notes

CAUTION:

When a supply unit of glove box lock cylinder shown in the illustration (A) is replaced, do not register a transponder ID using the bar code which is attached to the ignition key supplied simultaneously. If the transponder ID is registered with the attached bar code, the engine cannot start. However, only for vehicles without WCM, when one ignition key is used both for lock cylinder and engine start-up, it is necessary to replace a key set shown in the illustration (B).

Fig 1: Identifying Glove Box Lock
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When a key set in the illustration (B) is replaced, always register the transponder ID.

Fig 2: Identifying Key Set (Without WCM)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Identifying Key Set (With WCM)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The following bolts and screws are used for installing the instrument panel.

SCREW DIMENSIONS

Name	Symbol	Dimensions mm (screw diameter x screw length)	Color
Tapping screw	a	5 x 12	-
	b	5 x 16	-
	c	5 x 12	Black
	d	5 x 14	-
	e	5 x 16	-
	f	5 x 16	Black
	g	5 x 20	-
Washer-assembled bolt	h	6 x 16	-

CAUTION:

For the removal of the front passenger's air bag module, refer to SERVICE PRECAUTIONS , DRIVER'S AND FRONT PASSENGER'S AIR BAG MODULE, AND CLOCK SPRING before operation.
Do not subject SRS-ECU to any shocks when removing or installing the instrument panel.

Fig 4: Exploded View Of Instrument Panel Assembly Components
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.