lemon-mirror:
Home >> Mitsubishi >> 2012 >> Eclipse SE >> Repair and Diagnosis >> Electrical >> Gauges >> Combination Meter Assembly >> Symptom Procedures >> Data List Reference Table

Data List Reference Table

The following items of the ECU input data can be read using scan tool M.U.T.-III.

DATA LIST REFERENCE CHART

ITEM NO. CHECK ITEM CHECK CONDITION NORMAL CONDITION
05 Tachometer Start the engine. Tachometer displayed value and M.U.T.-III displayed value agree with each other.
06 Fuel gauge (Input) Ignition switch: ON Fuel gauge unit resistance value and M.U.T.-III displayed value agree with each other.
07 Fuel gauge (Target) Ignition switch: ON Fuel gauge and M.U.T.-III displayed values agree with each other.
08 ECT sensor Ignition switch: ON Engine coolant temperature and M.U.T.-III displayed values agree with each other.
09 Rheostat Ignition switch: ON The brightness of the combination meter illumination changes.
10 ABS indicator light - OFF
11 Door indicator light All doors are closed OFF
Any door is open ON
13 High beam indicator light Headlights: OFF or low-beam illuminates OFF
Headlights: High-beam illuminates ON
14 Brake indicator light
  • Ignition switch: ON
  • Parking brake: At release
OFF
  • Ignition switch: ON
  • Parking brake: OPERATION
ON
15 Charging indicator light - OFF
16 MIL - OFF
19 Front fog light indicator light Front fog light: OFF OFF
Front fog light: ON ON
20 Fuel warning light - OFF
21 Oil pressure indicator light - OFF
23 Seatbelt indicator light
  • Ignition switch: ON
  • Driver's seat belt: fastened
OFF
  • Ignition switch: ON
  • Driver's seat belt: Not fastened
ON
24 SRS indicator light - OFF
26 Turn signal indicator (Left) Turn-signal light: OFF or only right side light illuminates OFF
Turn-signal light: Left side light illuminates ON
27 Turn signal indicator (Right) Turn-signal light: OFF or only left side light illuminates OFF
Turn-signal light: Right side light illuminates ON
32 A/T position indicator: 1 Perform a test run of the vehicle. (Auto mode) OFF
Perform a test run of the vehicle. (Manual mode: 1st gear) ON
33 A/T position indicator: 2 Perform a test run of the vehicle. (Auto mode) OFF
Perform a test run of the vehicle. (Manual mode: 2nd gear) ON
34 A/T position indicator: 3 Perform a test run of the vehicle. (Auto mode) OFF
Perform a test run of the vehicle. (Manual mode: 3rd gear) ON
35 A/T position indicator: 4 Perform a test run of the vehicle. (Auto mode) OFF
Perform a test run of the vehicle. (Manual mode: 4th gear) ON
36 A/T position indicator: 5 Perform a test run of the vehicle. (Auto mode) OFF
Perform a test run of the vehicle. (Manual mode: 5th gear) ON
39 A/T position indicator: N Shift position: Other than N position OFF
Shift position: N position ON
40 A/T position indicator: P Shift position: Other than P position OFF
Shift position: P position ON
41 A/T position indicator: R Shift position: Other than R position OFF
Shift position: R position ON
42 Odometer Ignition switch: ON Odometer displayed value and M.U.T.-III displayed value agree with each other.
45 Power supply voltage Ignition switch: ON Battery voltage
46 Speedometer (Target) Ignition switch: ON Speedometer and M.U.T.-III displayed values agree with each other.
47 A/T position indicator: D Shift position: Other than D position OFF
Shift position: D position ON
50 Coolant Temp.confirmation flag Ignition switch: ON ON
51 Tire pressure indicator - OFF
52 Cruise control indicator - OFF
54 Speedometer (Input) Ignition switch: ON Speedometer and M.U.T.-III displayed values agree with each other.
55 Speed sensor failure flag Ignition switch: ON OFF
56 Speed sensor confirmation flag Ignition switch: ON ON
57 Vehicle stop flag Ignition switch: ON ON
59 ASC/TCL indicator When TCL or ASC system is operating ON
60 ASC OFF indicator ASC OFF switch: ON ON