lemon-mirror:
Home >> Mitsubishi >> 2014 >> RVR ES >> Repair and Diagnosis >> Electrical >> Charging Systems >> Generator Assembly >> Inspection >> Brush

Generator Assembly: Inspection: Brush

  1. Measure the length of the protrusion of the brush. Replace the brush if the protrusion length is shorter than the limit.

    Limit: 2 mm (0.1 inch) minimum 

  2. Unsolder the lead of the brush. The brush will come out, becoming ready for removal.
    Fig 1: Identifying Length Of Protrusion Of Brush
    G05393725Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install a new brush by pushing it into the holder as shown in the drawing and soldering the lead.
    Fig 2: Identifying Solder Location
    G05393726Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
· About lemon-mirror