Work Procedure

NOTE:

If Clutch Point Learning is also required, always perform Clutch Point Learning before Select Learning.
Perform Select Learning with CVT fluid temperature below 50° C (122 °F) and again with fluid temperature above 50 ° C (122 °F) .

PERFORM SELECT LEARNING (DRIVE/REVERSE LEARNING)
1. Set the parking brake.
2. Start the engine and wait 5 seconds.
3. Depress the brake pedal
4. Shift the selector lever to the N position and hold more than 2 seconds, then to D position and wait for transmission engagement.
5. Repeat step 3 ten (10) times.
6. Shift the selector lever to the N position and hold more than 2 seconds, then to R position and wait for transmission engagement.
7. Repeat step 5 ten (10) times.
8. Shift the selector lever to the P position and turn the ignition OFF.
>>

WORK END