Brake Control System
- Abs
- VDC/TCS/Abs
- Precautions
- Preparation
- On-Vehicle Service
- General Information
- Can Communication
- Trouble Diagnosis
- Notes
- How to Proceed With Diagnosis
- Component Installation Location
- Schematic
- Wiring Diagram - VDC -
- ABS Actuator and Electric Unit (Control Unit) Input/Output Signal Standard
- CONSULT-II Functions
- For Fast and Accurate Diagnosis
- Basic Inspection
- Symptom Chart
- Inspection 1 Wheel Sensor System
- Inspection 2 ABS Actuator and Electric Unit (Control Unit) System
- Inspection 3 Pressure Sensor and Circuit Between Pressure Sensor and ABS Actuator and Electric Unit (Control Unit)
- Inspection 4 Steering Angle Sensor and Circuit Between Steering Angle Sensor and ABS Actuator and Electric Unit (Control Unit)
- Inspection 5 Yaw Rate/Side/Decel G Sensor and Circuit Between Yaw Rate/Side/Decel G Sensor and ABS Actuator and Electric Unit (Control Unit)
- Inspection 6 Solenoid, VDC Switching Valve, Actuator Relay and Circuits
- DTC C1120, C1121, C1122, C1123, C1124, C1125, C1126, C1127, C1164, C1165, C1166, C1167 or C1140:
- Inspection 7 Actuator Motor, Motor Relay, and Circuit
- Inspection 8 Stop Lamp Switch and Circuit
- Inspection 9 ABS Actuator and Electric Unit (Control Unit) Power Supply and Ground Circuit
- Inspection 10 When "STEERING ANGLE SENSOR HAS NOT BEEN CORRECTED" Appears on Self-Diagnosis Results Display
- Inspection 11 Brake Fluid Level in Reservoir Tank, Communication Circuit Between ABS Actuator and Electric Unit (Control Unit) and Brake Fluid Level Switch
- Inspection 12 CAN Communications Lines, ABS Actuator and Electric Unit (Control Unit), Steering Angle Sensor System and CAN-LAN Converter ECU (CLC)
- Inspection 13 ENGINE SIGNAL 1 - Engine System
- Inspection 14 ENG SPEED SIG - Engine Speed Signal
- Inspection 15 ENG CHECK SIG - LAN Monitoring
- Inspection 16 LAN SIGNAL 2 - LAN Communication Start Procedure Incomplete
- Inspection 17 LAN COMM 1 - LAN Communication System Failure
- Inspection 18 LAN SIGNAL 3 - Continued Reception After LAN Communication Starts
- Inspection 19 SLIP Indicator Lamp Does Not Come On When Ignition Switch is Turned On
- Inspection 20 VDC OFF Indicator Lamp Does Not Come On When Ignition Switch Is Turned On
- Inspection 21 VDC OFF Switch Is Inoperative
- Inspection 22 CAN-LAN Converter Power Supply Circuit
- Inspection 23 CAN CIRCUIT 1 - CAN Communication System Failure
- Inspection 24 CAN-LAN Converter (CLC) Control Unit
- Inspection 25 ABS Warning Lamp Does Not Come On When Ignition Switch Is Turned On
- Inspection 26 When "DECEL G-SENSOR" Appears on Self-Diagnosis Results Display
- Removal And Installation