DIAGNOSTIC TROUBLE CODES Confirmation Procedure: Notes

CAUTION: Always drive vehicle at a safe speed.

NOTE:

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.
P0400 will not be displayed at "SELF-DIAG RESULTS" mode with CONSULT-II even though DTC work support test result is NG.

TESTING CONDITION:

Before performing the following procedure, confirm battery voltage is more than 10V at idle, then stop engine immediately.
For best results, perform the test at a temperature of 5°C (41°F) or higher.