lemon-mirror:
Home >> Nissan-Datsun >> 2008 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - Component Testing >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONNECTOR TERMINAL CONTINUITY SPECIFICATION

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

    Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04905835Courtesy of NISSAN MOTOR CO., U.S.A.
· About lemon-mirror