Mirror Motor Test
- To perform mirror motor test, remove mirror switch. Disconnect electrical connector. Using a 12-volt source, connect positive lead to one wire terminal and negative lead to other wire terminal as listed under TERMINALS in appropriate table.
- Reverse positive and negative leads on these wire terminals. Reverse leads again. Mirror motor should move UP and DOWN. Follow same procedure to test operation of LEFT/RIGHT motor.
NOTE:
On most models with mirror select switch, duplicate wire colors are used in circuit between mirror switch and mirror motors: one set of wires leads to driver's side mirror motors, other set leads to passenger's side mirror motors. When testing mirror motors on models with duplicate wire colors, connect battery positive lead to one wire terminal and battery negative lead to other wire terminal as specified in table. If mirror motor does not operate, leave positive lead connected. Disconnect negative lead and connect to other wire terminal of same color. If mirror motor does not operate, leave negative lead connected. Disconnect positive lead and connect to other wire terminal of the same color.
MIRROR MOTOR TEST SPECIFICATIONS
| Application | Terminals | Mirror Movement | ||
|---|---|---|---|---|
| Both Sides | YEL & LT GRN (1) | UP/DOWN | ||
| " | LT BLU & WHT (1) | LEFT/RIGHT | ||
|
||||