Electronic Ignition: Testing: Notes
NOTE:
If a suitable tester (C-4166 or C-4503 and their adapters) is available, use tester and follow manufacturer's instructions. If tester is not available, proceed as follows.
Visually check that all secondary cables, primary wire at coil and ballast resistor are not loose and not cracked excessively. Use a voltmeter with a 20, 000 ohm/volt rating and an ohmmeter which uses a 1 1/2 volt battery for its operation. Check calibration of both meters. Check and record battery voltage reading, using voltmeter. Proceed with the following tests.