Programming Memory

After previously programmed transmitters have been deleted from memory, the new transmitter codes need to be programmed into the receiver is accomplished by using the following procedure:

1. Vehicle ignition must be in the ON position.
2. Momentarily depress the Program switch on the receiver. See Figure . The operator shall have 10 seconds to program the first transmitter.
3. Operate any button on the first transmitter to program and store the security code for transmitter No. 1. The receiver shall the acknowledge successful programming by locking then unlocking the vehicle doors.
4. The operator shall have 10 seconds to program the next transmitter by repeating step  3 for transmitter No. 2.
5. After 2 transmitters have been trained, programming of the Keyless Entry system is complete. Wait 10 seconds after the second transmitter has been programmed and turn the ignition switch OFF to test the remote lock operation of the transmitters as a final check programming has been successful.