Programming Procedure
- Keyless entry receiver can be programmed to receive Vehicle Access Code (VAC) from any 2 random transmitters. To program a keyless entry module receiver, connect a jumper wire between Data Link Connector (DLC) terminals No. 4 and 8 (16-pin DLC) or terminals "A" and "G" (12-pin DLC). See Fig 1
or Fig 2
. Receiver will cycle door lock actuators within 1-3 seconds to acknowledge that receiver is in program mode.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.
- Press any button on transmitter once. In response, receiver will cycle door lock actuators to acknowledge that a transmission has been received. Press any button of second transmitter once. In response, receiver will cycle door lock actuators to acknowledge a transmission has been received. Remove fused jumper from DLC and verify system operation using all transmitter buttons.