lemon-mirror:
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure

Installation Procedure

IMPORTANT: Align the BCM to the console accessory wiring junction block.
  1. Install the BCM (1) onto the console accessory wiring junction block.
    Fig 1: View Of BCM Retaining Lever
    GM627743Courtesy of GENERAL MOTORS CORP.
  2. Rotate the BCM retaining lever (2) to secure the BCM to the console accessory wiring junction block.
  3. Install the console accessory wiring junction block. Refer to Console Electrical Center or Junction Block Replacement in Wiring Systems.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LA1) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
  5. Perform the new BCM setup. Refer to Body Control Module (BCM) Programming/RPO Configuration .
· About lemon-mirror