lemon-mirror:
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Strut, Strut Component and/or Spring Replacement >> Assembly Procedure

Assembly Procedure

  1. Install the coil spring and upper strut mount to the J 45400  . See Special Tools and Equipment .
    2. Fig 1: View Of Compressor Forcing Screw & Coil Spring
    GM743241Courtesy of GENERAL MOTORS CORP.
  2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
  3. Install the strut to the coil spring and upper strut mount.
  4. Loosely install the strut retaining nut.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Use a 45 TORX® socket in order to hold the strut shaft. Use the J 42991  to install the upper strut mount nut. See Special Tools and Equipment .

    Tighten:  Tighten the strut mount nut to 85 N.m (63 lb ft).

  6. Remove the strut from the J 45400  . See Special Tools and Equipment .
  7. Install the strut to the vehicle. Refer to Strut Assembly Replacement .
· About lemon-mirror