Installation Procedure

Fig 1: AC/DC Power Outlet Control Module & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the accessory AC/DC power control module (3) to the vehicle. Secure the module (3) with the 2 bolts (1).
Tighten: Tighten the power control module bolts to 7.0 N.m (62 lb in).
Fold the floor carpet to the inside.
Connect the electrical connector (2).
Move the drivers seat to it's original position.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.