lemon-mirror:
Home >> Pontiac >> 2005 >> G6 Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of BCM
    GM1207700Courtesy of GENERAL MOTORS CORP.
  1. Install the BCM.
  2. Install the BCM wire harness connectors.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the BCM screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the right console trim panel. Refer to Console Trim Panel Replacement - Right in Instrument Panel, Gages, and Console.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  6. For a new or remanufactured BCM, program the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration .
  7. Program the BCM after replacement. Refer to Control Module References .
· About lemon-mirror