lemon-mirror:
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing BCM Bracket Nuts
    GM581535Courtesy of GENERAL MOTORS CORP.
  1. Install the BCM bracket (1) as an assembly if required.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the BCM bracket nuts (2) if required.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

    3. Fig 2: Identifying BCM Lock Tabs
    GM763283Courtesy of GENERAL MOTORS CORP.
  3. Install the BCM into the BCM bracket until lock tabs are fully seated.
  4. Connect the BCM electrical connectors to the BCM.
  5. Install the BCM wire harness retainer to the BCM bracket.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. Reprogram the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration .
· About lemon-mirror