Installation Procedure
- Instal the remote control door lock receiver (2) to the mounting bracket (1), if removed.
- Install the remote control door lock receiver (1) to the vehicle.
- Install the bolt (3) to the door lock receiver (1).
Tighten: Tighten the remote control door lock receiver bolt to 10 N.m (89 lb in).
- Connect the remote control door lock receiver electrical connector (2).
- Install the right upper quarter panel trim. Refer to Trim Panel Replacement - Rear Quarter Upper in Interior Trim.
- Connect the negative battery cable.
- Reprogram the remote control door lock receiver, if necessary. Refer to Transmitter Programming in Keyless Entry.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.