Side Retainer

NOTE: After adjusting the drive pinion backlash and tooth contact, remove and install the oil seal and O-ring.

Remove O-ring.

Fig 1: Removing O-Ring

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Remove oil seal.

Fig 2: Removing Oil Seal

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Take out either split pin, remove claw.

ST 32005071 PULLER ASSY

Fig 3: Removing Claw

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Securely attach two claws to outer race, set ST to side retainer.

ST 32005071 PULLER ASSY

Fig 4: Installing ST 32005071 Puller Assy

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Return removed claw to the original position, and install pin and split pin.

Hold the shaft of ST to avoid removing from side retainer, and then remove the bearing outer race.

ST 32005071 PULLER ASSY

NOTE: Replace bearing inner and outer races as a single unit.

Fig 5: Removing Bearing Outer Race Using ST 32005071 Puller Assy

Courtesy of SAAB-SCANIA OF AMERICA, INC.