Before Programming The Engine Control Module
NOTE:
DO NOT program a control module unless you are directed by a service procedure or you are directed by a General Motors LLC service bulletin. Programming a control module at any other time will not permanently correct a customers concern.
Ensure the following conditions are met before programming a control module:
- Vehicle system voltage
- There is no charging system concern. All charging system concerns must be repaired before programming a control module.
- Battery voltage is between 12-16 V. The battery must be charged before programming the control module if the battery voltage is low.
- A battery charger is NOT connected to the vehicle battery. Incorrect system voltage or voltage fluctuations from a battery charger may cause programming error or control module damage.
- Turn OFF or disable any of the following systems that may put a load on the vehicle battery:
- Twilight sentinel
- Interior lights
- Daytime running lamps (DRL). Applying the parking brake, on most vehicles, disables the DRL system. Refer to the Owner's Manual.
- HVAC systems
- Engine cooling fans, etc.
- The ignition switch is in the proper position. The scan tool requests that you turn the ignition ON with the engine off. Do NOT change the position of the ignition switch unless you are requested to do so.
- All of the following tool connections are secure:
- The connection at the data link connector (DLC)
- The voltage supply circuits
- DO NOT disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming error or control module damage may occur.