lemon-mirror:
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Bus And Diagnostics Communication >> Adjustment Replacement >> Fuel Pump Flow Control Module Programming and Setup >> Fuel Pump Control Module Programming

Fuel Pump Control Module Programming

To program and setup an existing or new replacement fuel pump control module, perform the following procedure:

  1. With a scan tool, access Service Programming System (SPS) and follow the on-screen instructions. Refer to SERVICE PROGRAMMING SYSTEM (SPS) .
  2. On the SPS Supported Controllers screen, select CCM Fuel Pump Flow Control Module - Programming and follow the on-screen instructions.

If the fuel pump control module fails to accept the program, verify all scan tool and fuel pump control module connections are secure.

NOTE: After programming is completed, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF, for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, with the engine OFF
  5. With a scan tool, clear all DTC's from all modules.
· About lemon-mirror