lemon-mirror:
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Bus And Diagnostics Communication >> Adjustment Replacement >> Heated Seat Control Module Programming and Setup >> Seat Heating Control Module Programming

Seat Heating Control Module Programming

To program and setup an existing or new replacement seat heating control module, perform the following procedure:

  1. With a scan tool, access Service Programming System (SPS) and follow the on-screen instructions. Refer to SERVICE PROGRAMMING SYSTEM (SPS) .
  2. On the SPS Supported Controllers screen, select HVSMF Front Seat Heating Control Module - Programming and follow the on-screen instructions.

If the HVSMF Front Seat Heating Control Module fails to accept the program, verify all scan tool and seat heating control module connections are secure.

NOTE: After programming is completed, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF, for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, with the engine OFF
  5. With a scan tool, clear all DTC's from all modules.
· About lemon-mirror