To fit

Plug in the connector to the ignition switch module, see Connectors, handling and checking .

Fig 1: Identifying Ignition Switch Module Connector
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Lift up the floor console slightly and fit the ignition switch module. Make sure all four catches are in the correct position.

Fig 2: Installing Ignition Switch Module
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the floor console screws and tighten them. Put the rubber mat back into the storage compartment.

Fig 3: Identifying Floor Console Screws
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the cover under the handbrake lever.

Fig 4: Illustrations For Steps 4-5
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the compartment and cover on the passenger side.
AUT: Fit the clamp.

Fig 5: Identifying Clamp
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the cover over the gear lever housing.

Fig 6: Identifying Gear Lever Housing
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the front side pieces on the floor console.

Fig 7: Locating Front Side Pieces
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Connect Tech2 and clear any DTCs.