lemon-mirror:
Home >> Saab >> 2011 >> 9-3X Automatic >> Repair and Diagnosis >> Electrical >> Body Electrical >> General Electrical >> Repair Instructions - Control Modules >> Control module, door >> To remove

To remove

  1. Perform Preparations prior to changing a control module .
  2. Remove the Front door trim. See DOOR TRIM, FRONT .
  3. Lay the side of the door on a clean and soft surface.
  4. When changing the driver door module:  Remove the cell block from under the door module.
  5. When changing the driver door module:  Remove door trim screw.
    Fig 1: Illustration For Steps 5-6
    G05571126Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Remove the door module using a screwdriver. First undo the rear clip.

    Then undo the clips on the outer and inner sides of the door module. Pull the module carefully back/down.

· About lemon-mirror