Fuel Gauge
- Disconnect in-line fuel connector located in rear compartment behind driver's side carpet. Connect DVOM and Tester (SA9205Z)to terminals "B" and "C". With engine off, turn ignition switch to RUN position.
- Fuel gauge should indicate between full and empty depending on resistance setting. See FUEL GAUGE RESISTANCE table. Test fuel gauge beginning with low resistance setting to high resistance setting.
- If fuel gauge does not operate as specified, replace instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION.
FUEL GAUGE RESISTANCE
| Ohms | Fuel Gauge Reading |
|---|---|
| 31 | Full |
| 44.5 | Full Or Slightly Below |
| 92 | Middle Or Slightly Above |
| 106 | Middle Or Slightly Below |
| 204 | Empty Or Slightly Above |
| 301 | Empty |