lemon-mirror:
Home >> Saturn >> 2002 >> L200 Automatic >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Ignition Switch module Replacement >> Installation Procedure

Installation Procedure

Fig 1: Removing & Installing Multi-Function Levers
GM891750Courtesy of GENERAL MOTORS CORP.
  1. Use the new shear bolts to install the ignition module assembly on the steering column. Tighten the shear bolts until the heads break off.
  2. Install the turn signal/headlamp lever, the windshield washer lever, and the passlock sensor connector.
    3. Fig 2: Removing & Installing Multi-Function Levers
    GM891750Courtesy of GENERAL MOTORS CORP.
  3. Install the park lock solenoid.

    Tighten 

    Tighten the park lock solenoid screws to 1.5 N.m (14 lb in).

    4. Fig 3: Removing & Installing Ignition Switch
    GM881945Courtesy of GENERAL MOTORS CORP.
  4. Install the ignition switch and reconnect the ignition switch connector.

    5. Tighten 

    Tighten the park lock solenoid screws to 3 N.m (27 lb in).

  5. Install the shroud fasteners and the steering column lower shroud panel.
    Fig 4: Setting Ignition Module Actuator Blade In RUN Position Prior To Installation
    GM877940Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The actuator blade within the ignition module housing must be in the RUN position to install the lock cylinder assembly. If rotated, replace it to the RUN position using needle nose pliers.
  6. Insert the key into the ignition lock cylinder and install into the ignition module.
    7. Fig 5: Removing & Installing Ignition Lock Cylinder Bezel
    GM862575Courtesy of GENERAL MOTORS CORP.
  7. Install the steering column upper shroud panel.
  8. Install the lock cylinder bezel.
  9. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
· About lemon-mirror