lemon-mirror:
Home >> Saturn >> 2003 >> Ion 1 Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of EBCM & BPMV
    GM891775Courtesy of GENERAL MOTORS CORP.
  1. Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
  2. Install the EBCM (1) to the BPMV (2). Use care when aligning the EBCM (1) to the BPMV electrical terminals (3).
    3. Fig 2: View Of EBCM-To-BPMV Retaining Bolts
    GM891773Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 4 EBCM-to-BPMV retaining bolts (1). Tighten the bolts in a criss-cross pattern.

    Tighten:  Tighten the bolts to 3 N.m (27 lb in).

    4. Fig 3: View Of EBCM Electrical Connector
    GM890987Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the EBCM.
  5. Turn the ignition switch to the ON position. DO NOT start engine.
  6. Perform the Diagnostic System Check - ABS .
· About lemon-mirror