lemon-mirror:
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Controls (Introduction)) >> Repair Instructions >> Accelerator Controls Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the accelerator bracket (2) on the throttle body (1).

    Tighten:  Tighten the accelerator bracket bolts to 10 N.m (89 lb in).

    2. Fig 1: View Of Accelerator Bracket
    GM889862Courtesy of GENERAL MOTORS CORP.
  2. Connect the accelerator control cable to the throttle body and accelerator bracket.
    3. Fig 2: Identifying Accelerator Control Cable
    GM851308Courtesy of GENERAL MOTORS CORP.
  3. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
· About lemon-mirror