lemon-mirror:
Home >> Saturn >> 2005 >> Ion Red Line >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the BCM to the vehicle and install the retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

    2. Fig 1: View Of BCM
    GM877750Courtesy of GENERAL MOTORS CORP.
  2. Connect the large I/P wiring harness connector (2) to the BCM.
    3. Fig 2: View Of BCM I/P Wiring Harness Connectors
    GM877747Courtesy of GENERAL MOTORS CORP.
  3. Connect the small I/P wiring harness connector (1) to the BCM.
  4. Connect the large body wiring harness connector (2) to the BCM.
    5. Fig 3: View Of BCM Body Harness Connectors
    GM877745Courtesy of GENERAL MOTORS CORP.
  5. Connect the small body wiring harness connector (1) to the BCM.
  6. Connect the OnStar® connector.
  7. Pull back the carpet and position the center support bracket into position.
  8. Install the center support bracket nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

    9. Fig 4: View Of Center Support Bracket
    GM877820Courtesy of GENERAL MOTORS CORP.
  9. Install the wiring harness rosebud to the center support bracket.
    10. Fig 5: View Of Wiring Harness Center Support Bracket
    GM877821Courtesy of GENERAL MOTORS CORP.
  10. Install the front floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  12. Program a new or a remanufactured BCM. Refer to Control Module References .
· About lemon-mirror