lemon-mirror:
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Body Control System) >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the I/P compartment partially into the opening.
    Fig 1: Partially Installing I/P Compartment
    GM896914Courtesy of GENERAL MOTORS CORP.
  2. Secure the BCM to the I/P compartment slots
  3. Install the BCM harness connectors.
  4. Route the lamp wiring harness through the lamp opening and connect the wiring harness to the I/P compartment lamp.
  5. Snap the lamp into the compartment bin.
    Fig 2: Installing I/P Compartment Lamp Assembly
    GM896878Courtesy of GENERAL MOTORS CORP.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the I/P compartment bin with fasteners. Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).
  7. Install the I/P compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment in Instrument Panel, Gages, and Console.
  8. Install the right side heater outlet to the I/P compartment bin using the retainers.
    Fig 3: Installing Right Side Heater Outlet To I/P Compartment Bin Using Retainers
    GM897891Courtesy of GENERAL MOTORS CORP.
  9. Install the closeout panel to the right side lower I/P using the retainers.
    Fig 4: Installing Closeout Panel To Right Side Lower I/P
    GM896491Courtesy of GENERAL MOTORS CORP.
  10. Operate the I/P compartment lamp and the I/P compartment door to ensure proper operation.
  11. Program the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration .
· About lemon-mirror