How To Proceed With Troubleshooting

The hand-held tester can be used at step  3,  6,  9 and  12.

1. Vehicle Brought to Workshop 
   1. GO TO NEXT STEP 
2. Customer Problem Analysis (See  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
   1. GO TO NEXT STEP 
3. Check and Clear DTCs and Freeze Frame Data (See  DTC CHECK/CLEAR   and  FREEZE FRAME DATA OF ABS  ) 
   1. GO TO NEXT STEP 
4. Problem Symptom Confirmation (See  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 
   1. Symptom does not occur: Go to step   5 
   2. Symptom occurs: Go to step   6 
5. Symptom Simulation (See  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
   1. Go to next STEP 
6. DTC Check (See  DTC CHECK/CLEAR   ) 
   1. There is no output: Go to step   7 
   2. There is output: Go to step   8 
7. PROBLEM SYMPTOMS TABLE  ) 
   1. Check for fluid leakage and Go to step   10 
8. DTC Table (See  DIAGNOSTIC TROUBLE CODE TABLE  ) 
   1. Go to next STEP 
9. Circuit Inspection (See  DTC C0200/31, C0205/32, C1235/35, C1236/36: RIGHT FRONT SPEED SENSOR CIRCUIT, LEFT FRONT SPEED SENSOR CIRCUIT, FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR FRONT SENSOR   to  TC TERMINAL CIRCUIT   ) 

   HINT: When 2 or more DTCs are recorded, and the problem is not identified, perform circuit inspection of the other DTCs.

   1. Go to next STEP 
10. Identification of Problem 
    1. Go to next STEP 
11. Repair 
    1. Go to next STEP 
12. Confirmation Test 
    1. End