Read Data List

Using the hand-held tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Read the DATA LIST according to the display on the tester.

   ECM: 

   DATA LIST TEST
   
   

   Item	Measurement Item/ Range (Display)	Normal Condition	Diagnostic Note
   ENGINE SPD	Engine speed/ Min.: 0 rpm, Max.: 16,383 rpm	Almost equal to actual engine speed (when engine is running)	-
   COOLANT TEMP	Coolant Temperature/ Min.: -40°C (-40°F), Max.: 140°C (284°F)	After warming up: 80 to 95°C (176 to 203°F)	If value is -40°C (-40°F) or 140°C (284°F), sensor circuit is open or shorted.

   Skid control ECU with Actuator: 

   ACTIVE TEST
   
   

   Item	Measurement Item/ Range (Display)	Normal Condition	Diagnostic Note
   WHEELSPD FR	Vehicle speed/ Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)	Almost equal to speedometer value (when driving)	-
   WHEELSPD FL	Vehicle speed/ Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)	Almost equal to speedometer value (when driving)	-
   WHEELSPD RR	Vehicle speed/ Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)	Almost equal to speedometer value (when driving)	-
   WHEELSPD RL	Vehicle speed/ Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)	Almost equal to speedometer value (when driving)	-