lemon-mirror:
Home >> Scion >> 2008 >> tC Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> U241E Automatic Transaxle >> Transmission Control Cable Assembly >> Removal

Transmission Control Cable Assembly: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE AIR CONDITIONING RADIATOR ASSEMBLY  (See REMOVAL )
  3. REMOVE EXHAUST PIPE ASSEMBLY 
    1. Remove the exhaust pipe (See REMOVAL ).
  4. REMOVE ENGINE UNDER COVER LH 
  5. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Remove the nut from the control shaft lever.
      2. Fig 1: Identifying Nut From Control Shaft Lever
      G05539409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the cable from the control shaft lever.
      3. Fig 2: Identifying Cable From Control Shaft Lever
      G05539410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the clip and disconnect the cable from the control cable bracket.
    4. Disconnect the cable from the control cable clamp.
      Fig 3: Identifying Cable From Control Cable Clamp
      G05539411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Remove the 2 bolts and disconnect the No. 2 shift cable grommet retainer.
      Fig 4: Identifying Shift Cable Grommet Retainer And Bolts
      G05539412Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the floor shift cable from the transmission floor shift assembly.
    3. Pull out the cable from the body.
    4. Remove the No. 2 shift cable grommet retainer.
      Fig 5: Identifying No. 2 Shift Cable Grommet Retainer
      G05539413Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror