Ignition Switch: Installation

INSTALL IGNITION SWITCH ASSEMBLY
1. Install the ignition switch assembly with the 2 screws.
  
  Fig 1: Identifying Ignition Switch Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the wire harness clamp and connect the 2 connectors.
  
  Fig 2: Locating Wire Harness Clamp Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN COVER (for Lower Side)
NOTE: If the steering column cover is installed in the incorrect order, it will not be possible to assemble the steering column cover.
1. Engage the 2 claws to install the steering column cover.
  
  Fig 3: Identifying Steering Column Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 4 claws.
  
  Fig 4: Identifying Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the claw.
  HINT:
  
  Press the area around the claw to engage it.
Fig 5: Locating Claw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )
INSTALL STEERING PAD (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )