2ZR-FE Charging: Generator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER RH
REMOVE NO. 2 CYLINDER HEAD COVER (See REMOVAL )
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
1. Remove 2 bolts and remove the engine mounting stay RH.
  
  Fig 1: Locating Engine Mounting Stay RH And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Place a wooden block on a jack underneath the engine.
  
  Fig 2: Placing Wooden Block On Jack Underneath Engine
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 6 bolts and nut and remove the engine mounting insulator sub-assembly RH.
  NOTE: Do not remove bolt A.
  
  Fig 3: Locating Engine Mounting Insulator Sub-Assembly RH, Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSVERSE ENGINE MOUNTING BRACKET
1. Remove the 3 bolts and remove the engine mounting bracket.
  
  Fig 4: Locating Engine Mounting Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE GENERATOR ASSEMBLY
1. Remove the 2 bolts and remove the fan belt adjusting bar.
  
  Fig 5: Locating Fan Belt Adjusting Bar Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the terminal cap.
3. Remove the nut and remove terminal B.
4. Disconnect the connector and harness clamp.
  
  Fig 6: Locating Connector And Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the bolt and remove the generator assembly.
6. Remove the bolt and remove the wire harness bracket.