Transmission Control Cable: Installation

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the control cable with the 3 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Locating Transmission Control Cable Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the control cable assembly onto the control cable bracket with 2 new clips.
3. Connect the control cable assembly and install the 2 washers and 2 clips.
4. Install the control cable assembly onto the shift lever retainer.
  NOTE:
  - Install the cable with the protruding portion of the cable outer facing upward.
  - After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.
    
    Fig 3: Identifying Control Cable Assembly Onto Shift Lever Retainer
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the control shift cable to the shift lever.
6. Connect the control select cable to the shift lever with the clip.
  NOTE:
  - Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.
  - Insert the clip in the direction shown in the illustration.
    
    Fig 4: Locating Shift Cable And Select Cable
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Adjust the length of the control select cable.
  1. Slide the adjuster case cover in the direction shown in the illustration (Illustration A).
  2. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
  3. Press the lock piece into the adjuster case and lock it (Illustration B).
  4. Slide the cover in the direction shown in the illustration (Illustration C).
    NOTE: Slide the cover past the protrusion portion of the lock piece (Illustration D).
    
    Fig 5: Sliding Adjuster Case Cover
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
1. Install the front No. 1 floor heat insulator with the 2 bolts and nut.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 6: Locating Front No. 1 Floor Heat Insulator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
CONNECT HEATED OXYGEN SENSOR CONNECTOR
INSTALL FRONT FLOOR CENTER BRACE (See INSTALLATION )
INSTALL FRONT CONSOLE BOX (See INSTALLATION )
INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE BOX CARPET (See INSTALLATION )
INSTALL CONSOLE BOX REAR COVER (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (See INSTALLATION )