DTC P060A: Internal Control Module Monitoring Processor Performance: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear DTC. Refer to DTC CHECK / CLEAR .
5. Turn the ignition switch to OFF and turn the tester OFF.
6. Disconnect the tester.
7. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
8. Connect the cable to the battery negative (-) terminal.
9. Connect the tester to the DLC3.
10. Turn the ignition switch to ON.
11. Turn the Techstream on.
12. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
13. Read the DTCs.

    Result

    Result	Proceed to
    No output	A
    P060A	B

B → See step   3 

A → See step   2