lemon-mirror:
Home >> Scion >> 2011 >> tC Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Steering Angle Sensor >> Installation >> Installation

Steering Angle Sensor: Installation: Installation

  1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 

    Refer to INSTALLATION - Step 1

    NOTE:
    • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
    • Do not rotate the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
    • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
    • Do not remove the steering angle sensor from the spiral cable with sensor sub-assembly.
  2. INSTALL STEERING COLUMN COVER  . Refer to INSTALLATION - Step 11
  3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  4. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY  . Refer to INSTALLATION - Step 3
  5. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION

· About lemon-mirror