NIPPONDENSO Electronic Ignition System: Overhaul: Reassembly

Assemble in reverse order of disassembly, noting the following:

• Lightly grease timing rotor (reluctor) inner surface. Install on shaft aligning mark on stopper plate ("10.5" on Isuzu and LUV, "15.5" on Subaru, "12" on Celica, Corona and Pickup, "10" on Corolla, "14" on Starlet, "8" on Supra and Cressida, and "11.5" on Tercel).
• When installing breaker plate, align 4 clips of plate with 4 grooves in housing.
• When replacing pinion, replace pin and pinion as a set. Adjust air gap between timing rotor and pick-up coil.