lemon-mirror:
Home >> Subaru >> 2002 >> Forester Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security & Locks >> Keyless Transmitter >> Replacement >> Transmitter Registration

Transmitter Registration

NOTE: Perform programming when the transmitter is replaced and when an additional transmitter is required.
NOTE: Finish operation from step 1) through 4) within 45 seconds.
  1. Sit on the driver's seat and close all doors, rear gate.
  2. Open the driver's door.
  3. Close the driver's door.
  4. Turn the ignition switch from ON to LOCK ten times within 15 seconds.
    NOTE: Do not start the engine at this time.
  5. The horn chirps one time to indicate that the system has entered in the programming mode.
  6. Open the driver's door.
  7. Close the driver's door.
  8. Press any button on the transmitter that you wish to program into the system.
  9. Horn will chirp two times to indicate that the transmitter has been programmed.
    NOTE: Any additional transmitter can also be programmed at this time. Repeat steps  6 through  9 for an additional transmitter.
  10. Remove the ignition key from the ignition switch.
  11. The horn will chirp three times to indicate that the system has exited the programming mode.
  12. Check the keyless entry system properly operates by operating each transmitter.
· About lemon-mirror