lemon-mirror:
Home >> Subaru >> 2003 >> Baja Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Trans (Diagnostics) >> Subaru Select Monitor >> Operation >> Read Current Data

Read Current Data

  1. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
  2. On the "System Selection Menu" display screen, select the {Transmission Control System} and press the [YES] key.
  3. Press the [YES] key after displayed the information of transmission type.
  4. On the transmission Diagnosis" display screen, select the {Current Data Display & Save} and press the [YES] key.
  5. On the "Data Display Menu" display screen, select the {Data Display} and press the [YES] key.
  6. Using the scroll key, move the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
    DISPLAY CONTENTS

    Contents Display Unit of measure
    Battery voltage Battery Voltage V
    Rear vehicle speed sensor signal Rear Wheel Speed km/h or MPH
    Front vehicle speed sensor signal Front Wheel Speed km/h or MPH
    Engine speed signal Engine Speed rpm
    Automatic transmission fluid temperature signal ATF Temp. °Cor°F
    Throttle position signal Throttle Sensor Voltage V
    Gear position Gear Position -
    Line pressure control duty ratio Line Pressure Duty Ratio %
    Lock up clutch control duty ratio Lock Up Duty Ratio %
    Transfer clutch control duty ratio Transfer Duty Ratio %
    Power supply for throttle position sensor Throttle Sensor Power V
    Torque converter turbine speed signal Turbine Revolution Speed rpm
    2-4 brake timing pressure control duty ratio Brake Clutch Duty Ratio %
    Intake manifold pressure sensor voltage Mani. Pressure Voltage V
    FWD switch signal (Without VDC system and SPORT shift) FWD Switch ON or OFF
    Stop lamp switch signal Stop Light Switch ON or OFF
    SPORT shift mode signal Tip Mode Switch ON or OFF
    Shift-up signal (With SPORT shift) Down Switch ON or OFF
    Shift-down signal (With SPORT shift) Up Switch ON or OFF
    Anti lock brake system signal ABS Signal ON or OFF
    Cruise control system signal Cruise Control Signal ON or OFF
    Parking range signal P Range Signal ON or OFF
    Neutral range signal N Range Signal ON or OFF
    Reverse range signal R Range Signal ON or OFF
    Drive range signal D Range Signal ON or OFF
    3rd range signal 3rd Range Signal ON or OFF
    2nd range signal 2nd Range Signal ON or OFF
    1st range signal 1st Range Signal ON or OFF
    Shift control solenoid A Shift Solenoid #1 ON or OFF
    Shift control solenoid B Shift Solenoid #2 ON or OFF
    Torque control output signal #1 Torque Control Signal 1 ON or OFF
    Torque control output signal #2 Torque Control Signal 2 ON or OFF
    Torque control cut signal Torque Control Cut Sig. ON or OFF
    2-4 brake timing control solenoid valve 2-4 Brake Timing Sol. ON or OFF
    Low clutch timing control solenoid valve Low Clutch Timing Sol. ON or OFF
    SPORT shift solenoid valve (With SPORT shift) Tip solenoid ON or OFF
    Automatic transmission diagnosis indicator lamp Diagnosis Lamp ON or OFF
    Automatic transmission fluid temperature lamp ATF Temperature Lamp ON or OFF
NOTE: For detailed operation procedure, refer to the Subaru Select Monitor  .