lemon-mirror:
Home >> Subaru >> 2003 >> Baja Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Trans) >> Extension Case >> Installation

Extension Case: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Attach the selected thrust needle bearing to the end surface of reduction drive gear with vaseline.
    NOTE: Install thrust needle bearing in the correct direction.
  2. Install new gasket.
  3. Install the extension case to the transmission case.
  4. Tighten bolts to secure the case.
    1. Tightening torque:  25 N.m (2.5 kgf-m, 18.1 ft-lb)
    Fig 1: Tightening Bolts To Secure Case
    G02875881Courtesy of SUBARU OF AMERICA, INC.
  5. Install the rear vehicle speed sensor.
    1. Tightening torque:  7 N.m (0.7 kgf-m, 5.1 ft-lb)
    Fig 2: Installing Rear Vehicle Speed Sensor (MPT Model)
    G02875882Courtesy of SUBARU OF AMERICA, INC.
    Fig 3: Installing Rear Vehicle Speed Sensor (VTD Model)
    G02875883Courtesy of SUBARU OF AMERICA, INC.
  6. Install the transmission assembly. < Ref. to INSTALLATION , Automatic Transmission Assembly.>
· About lemon-mirror