lemon-mirror:
Home >> Subaru >> 2005 >> Outback R >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Security System >> Inspection >> Check Security Indicator Light Circuit

Check Security Indicator Light Circuit

STEP CHECK SHEET

Step Check Yes No
1. CHECK SECURITY INDICATOR LIGHT. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the harness connector of body integrated unit.
  3. Connect the resistor (100 Ω) between body integrated unit harness connector terminal (i84) No. 33 and body ground.

Connector & terminal 

(184) No. 33 - Chassis ground: 

 Does the security indicator light illuminate? Check the body integrated unit. < Ref. to , BASIC DIAGNOSTIC PROCEDURE . > Go to step 2. 
2. CHECK POWER SUPPLY FOR SECURITY INDICATOR LIGHT. 
  1. Disconnect the connector from combination meter.
  2. Measure the voltage between the combination meter harness connector terminal and chassis ground.

Connector & terminal 

(i10) No. 1, 2 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Go to step 3.  Check the harness for open or short circuit between combination meter and fuse.
3. CHECK SECURITY INDICATOR LIGHT CIRCUIT. 

Measure the resistance between the combination meter harness connector terminal and security control unit harness connector terminal.

Connector & terminal 

(i10) No. 17 - (i84) No. 33: 

 Is the resistance less than 10 Ω? Replace the combination meter. < Ref. to COMBINATION METER . > Check the harness for open or short circuit between combination meter and body integrated unit.
· About lemon-mirror