lemon-mirror:
Home >> Subaru >> 2005 >> Outback R >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Speed Control Systems (H4SO)) >> Accelerator Control Cable >> Installation

Accelerator Control Cable: Installation

WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install in the reverse order of removal.
  2. Apply grease to the point (accelerator cable end on engine side) shown in the figure below.

    Part No. 004404002 (Slico lube G-30M)

    Fig 1: Applying Grease To Cable
    G03748726Courtesy of SUBARU OF AMERICA, INC.
    CAUTION:
    • If cable clamp is damaged, replace it with a new one.
    • Never fail to cover outer cable end with boot.
    • Be careful not to kink accelerator cable.
    • Do not apply grease except for special area.
  3. Adjustment after pedal installation < Ref. to , INSTALLATION , Accelerator Pedal. >
· About lemon-mirror