Intake Manifold: Assembly

Liquid gasket: 

THREE BOND 1105 (Part No. 004403010) 

1. Tighten the bolts which install fuel pipes on intake manifold.

   Tightening torque: 

   6.4 N.m (0.65 kgf-m, 4.7 ft-lb) 

   Fig 1: Locating Fuel Pipes Bolts (1 Of 2)

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 2: Locating Fuel Pipes Bolts (2 Of 2)

   Courtesy of SUBARU OF AMERICA, INC.
2. Connect the fuel injector pipe to fuel hose, and tighten the clamp screw.

   Tightening torque: 

   1.5 N.m (0.15 kgf-m, 1.1 ft-lb) 

   Fig 3: Locating Fuel Injector Pipe Clamp

   Courtesy of SUBARU OF AMERICA, INC.
3. Install the purge control solenoid valve. < Refer to INSTALLATION , Purge Control Solenoid Valve. >
4. Install the manifold absolute pressure sensor. < Refer to INSTALLATION , MANIFOLD ABSOLUTE PRESSURE SENSOR. >
5. Install the throttle body to intake manifold. < Refer to INSTALLATION , THROTTLE BODY. >
6. Install the engine harness to the intake manifold.